Change DLM of a Renesas RA6M5 using J-Link Base

    This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

    • Change DLM of a Renesas RA6M5 using J-Link Base

      Hello,
      We need to modify the DLM of our RA6M5 from CM to SSD. We have a J-Link Base and a J-Link-OB-S124 of the EK-RA6M5. With the J-Link-OB-S124 we are capables of do it, but with the J-Link Base we are not. Is there any difference between both? From Renesas support they indicates us, that with the J-Trace Pro that they have, they can modify this register.

      Could you indicate us if with the J-Link Base is possible to do it? Or we have to get any other option available?

      We have read from Segger documentation that with a Segger Flasher this could be done also.

      Best Regards,

    • Hi,

      I am assuming that you use the DLM tools in e2studio for this, correct?
      In general, it should work with any current J-Link model.

      Can you please tell us what J-Link Commander outputs at “Firmware: xxx” for your J-Link BASE?
      Just to make sure that the J-Link in question is not too old.
      Please read the forum rules before posting.

      Keep in mind, this is *not* a support forum.
      Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
      Should you be entitled to support you can contact us via our support system: segger.com/ticket/
      Or you can contact us via e-mail.

    • Hello,
      Thank you for the answer and sorry for the delay to give you the data (summer holidays....)

      Yes we use e2studio for that.

      This is the info form J-Link Commander:
      Images

      • Jlink_version.png

        16.89 kB, 599×149, viewed 89 times