JScope fails to find RTT block

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • JScope fails to find RTT block

    Hi,

    Because JScope HSS sampling is currently not working for me (see forum.segger.com/index.php/Thr…Failed-to-initialize-HSS/), I'm trying to get JScope working using RTT mode.
    I've configured an up buffer and write data to it. The RTT viewer can find the control block almost immediately and shows the additional channel:
    [img='blob:https://forum.segger.com/81c4fa6a-226e-46b0-9b06-e56dc2b199cf',none,401][/img]
    But when I then start JScope it tries to find the control block for a while and then bails out with the message that the control block can not be found.
    Did I configure something wrong?

    Thanks in advance.

    Kind regards,

    Remco Poelstra
  • Hello,

    I apologize for the delay in response.

    Did you follow the J-Scope RTT guide? You can find it here:
    J-Scope RTT Guide

    Best regards,
    Simon
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.
  • Hello,

    I am not able to see your screenshot. Could you please try to re-upload it?

    Best regards,
    Simon
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.
  • Hello,

    I can not see any possible issues in your picture.

    For further investigation, could you please create a ticket for this issue:
    segger.com/support/technical-support/

    The ticket should contain the following information:
    1. Serial number of your J-Link
    2. Used Hardware
    3. Software Version used
    4. Simplified example project to reproduce the issue
    Once the issue is resolved, we will update this case accordingly.

    Best regards,
    Simon
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.

    The post was edited 1 time, last by SEGGER - Simon ().