Hi guys,

I already read in the forums about possiblities to specify the address of the RTT control block to J-Scope, unfortunately I was not successful yet.
I have a setup where I use RTT on the µC side (STM32L4), setting up an "up" channel for RTT on channel index1. I use the naming convention of the RTT channel as documented in chapter 1.11 (Instrumenting an application to use it with J-Scope) of the document UM08028.

I AM able to log channel1 via RTTLogger when I pass the address of the control block to segger RTT as documented. However, no luck wihr J-Scope, which always tells me that the control block cannot be found. I found this thread:

[SOLVED] J-Scope, finding RTT

and ran J-Scope with
JScope.exe --rttsearch "0x10000000 0x1000"

I know that 0x10000000 is the correct address since specifying it to RTTLogger works, but J-Scope seems to ignore that information (latest J-Scope version)


Any ideas how to make J-Scope work to find the Control block and graphing the data arriving over RTT channel 1?


Thanks and BR,

Franz

Hi Matthias and thanks for the reply!

Until then, can you maybe tell me the latest version of J-Scope that still had the mentioned feature built-in?

Thanks and BR,
Franz