[SOLVED] Getting output from user actions in Ozone

v01d · Feb 11th 2018, 6:55am

Is it possible to get the output of the User Actions command inside Ozone?

E.g. I do Target.ReadU32( 0x80000004) .

When I do this from Ozone's Console window, command seems runs, but I get no output. Is there special window .. ?

SEGGER - Nino · Feb 12th 2018, 5:14pm

Hello,

Thank you for your inquiry.

To enable Ozone log do the following:
launch "Ozone --logfile <logfile>" where <logfile> is the logfile path. More information are available in the Ozone manual.

Best regards,
Nino

v01d · Feb 13th 2018, 12:18pm

Does this mean you cannot get output of those commands in Ozone 's console .. ?
(Same as with JLink commander : read memory, it prints output ).

Did not plan to log anything ..

SEGGER - Nino · Feb 14th 2018, 12:05pm

Hi,

Does this mean you cannot get output of those commands in Ozone 's console .. ?

Correct.
The Ozone log will log everything that you see and enter in the Ozone Console.

Most commands you see in the action table of the Ozone user manual will not print any return value in the Console as they are meant to be used with the Ozone scripting interface.
For memory reads and writes while debugging we suggest using the memory window.

Best regards,
Nino

Share