Jlink pro reg not reset

I have an issue where Segger V7.98 isn't properly resetting the device registers on startup.

Example, STM32L4P5 register PLLCFGR and TAMP settings don't automatically reset to default values.

I'm using Crossworks 5.0.3? on win10 if it makes any difference here.

In V7.98, every time I start a debug session this PLL value is wrong. So I have to start execution, then restart before the PLLCFGR value is at the reset value.

In V7.68, this happens similarly except only the first time the device is powered up.

I've been working with Crossworks on this, they have suggested I talk to Segger.

I can confirm that "r" resets the register. Some testing notes:

PLLCFGR reset value is 0x00001000
PLLCFGR address is 0x4002100C

Following JLINK commander "erase", PLLCFGR value is 0x01001412
"r" resets this to 0x00001000

I've attached the jlink output log after a program attempt, which yields the wrong initial PLLCFGR value.