[SOLVED] Jlink 5V output

https://www.segger.com/products/debug…ce-description/
shows a 5 Volt output on pin 19 while there is no output at my Jlink on pin 19.
Assume the 6 pin IC beside the uper left mounting hole is a voltage regulator,
pin 2+3 have 5V while pin 6 (output ?) is 0Volt. Same behaviour at my JTrace.

Is this a HW problem or do I have to enable the output in Ozone ?

Thanks, I never used this command to enable 5V but we have a target what uses the 5 V pin already successfull. Maybe a former colleague enabled the 5V and all other used without knowing about. Will the permanent setup survive a Firmware update what occurs frequently if changing the Jlink between a Win and Linux Host ?

The POWER command works with both of my cables Jlink and Jtrace, while the VTREF command only works with Jtrace although Jlink purchase is much newer.

Firmware: J-Link V9 compiled May 7 2021 16:26:12
Hardware: V9.30

Firmware: J-Trace PRO V1 Cortex-M compiled Jul 28 2021 10:11:34
Hardware: V1.00

Are there any HW version prerequisites to use the Jlink commands ?