jonestn Community Member

I've confirmed that I can work around the issue using Pylink's open(), connect(), read(), close() operations each time I need to use the J-Link API. In hindsight, the lack of a J-Link disconnect() operation should have been a red flag as well as the…

Running with J-Link v7.98g software and a J-Link Plus USB probe S/N 601006986 and nrfjprog 10.24.0 Test 1; 1) Connect J-Link Plus to target device (with a Laird BL652) 2) Start J-Flash, open nRF52832_xxAA device, SWD speed 4000 3) Erase chip, program &…

After further investigation, I've confirmed that "nrfjprog --reset" is doing the same reset as J-Flash. I'm looking for the device to go into low power mode after programming (~2uA at 3v). It does after J-Flash (F9) but not after my programmatic…

I've written a custom manufacturing programming tool for ARM Cortex-M4 nRF52832 and nRF52810 devices. It uses a J-Link Plus USB programmer (J-Link V7.98g) and is implemented in Python using the Pylink package. The program configures J-Link to use SWD and…