andrewsglenn Community Member

  • Member since May 20th 2021
Last Activity

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • andrewsglenn -

    Replied to the thread JLinkGDBServerCL connects, Ozone does not.

    Post
    Hi Alex, Strange. I just regenerated them, so hope this helps. I've added the schematic for the debug connector. My assumption is if they changed the port configuration, then JLinkGDBServerCL would fail to connect? Glenn

  • andrewsglenn -

    Replied to the thread JLinkGDBServerCL connects, Ozone does not.

    Post
    Hopefully these are the correct files. I tried using JLinkCommander to set the default log file generation but apparently I'm too stupid to run it. I've also regenerated the jdebug file from the project wizard. The only change I made was ad the log…

  • andrewsglenn -

    Replied to the thread JLinkGDBServerCL connects, Ozone does not.

    Post
    Hi Alex Please find attached the log file. > I noticed that in your Ozone project file the function _SetupTarget() is never called. Is that intended? I used the defaults from the Ozone project wizard. I assumed it set things up correctly for…

  • andrewsglenn -

    Posted the thread JLinkGDBServerCL connects, Ozone does not.

    Thread
    NXP LPC54S018 Development board (LPCXpresso54S018) Using the NXP IDE with my J-Link Plus Compact, I get connection errors, so I thought I'd try with Ozone. The JLinkGDBServerCL commandline is as follows: 'C:\Program…