SEGGER - AlexD Administrator

Hi AndyR, on which device, exactly do you observe that behavior? We shall try to reproduce locally. Best regards -- AlexD

H Namklak, Ozone does not support sending such control characters to the target. Best regards -- AlexD

Hi AndyR, could you please provide a J-Link log and an Ozone log, both recorded during the same session where the issue is reproduced? How to create an Ozone log is described in chapter 8 of the Ozone user's manual. Creating a J-Link log file is…

Hi AndyR, please refer to the Ozone user' manual, section 4.6.1, where the hardware requirements for the data sampling window are listed. There you can see that you can control background memory access emulation via the system variable…

Hi fraengers, thank you. We will try to reproduce and come back to you. This might take a while since all engineers are currently fully booked. Best regards -- AlexD

Hi AndyR, I'm sorry but I am not able to comprehend the point of your inquiry. Could you please describe more clearly what exactly you would like to know or understand? Best regards -- AlexD

Hi Hi Charles_1, good to see you are up and running again. We will consider this thread as closed now. Thanks for sharing this with us and best regards -- AlexD

Hi fraengers, we were able to reproduce the issues from bullet point #1 and #2. We will provide fixes in a future release of Ozone. Best regards -- AlexD

Hi Charles_1 your inquiry is no longer Ozone specific. You are facing general connection issues, which cannot be handled by Ozone team but need to be handled by the J-Link team. If my understanding is correct, you are now able to attach to your device.…

Hi Charles_1, just a guess: Does your RTOS enter a power-saving mode when entering the idle thread? In that case, please have a look here: wiki.segger.com/J-Link_Low-power_mode_debugging Best regards -- AlexD

Hi apullin, thanks for your inquiry. Ozone does not provide such a feature. Best regards -- AlexD

Hi keijan2000, as stated before, due to the strong interlinking of Ozone and the ELF file, a snapshot cannot operate properly without the original ELF file. So I kindly suggest to archive the respective ELF file together with the snapshot, allowing you…

Hi Keijan, we are able to reproduce the issue, thanks to your reproducer. Deeper analysis is required which we cannot do right now. A fix, once available, will be provided in a future Ozone version. Best regards -- AlexD

Hi kejian2000, Thanks for your suggestion. Please refer to the user's manual, section 3.11.11.1 Load Snapshot: "In particular, the program file must binary-match the program file at the time the snapshot was saved." The scenario you describe is…

Hi kejian2000, we will try to reproduce and report back here later. Best regards -- AlexD

Hi Keijan2000, thanks for the explanation. I will close this thread now. Best regards -- AlexD