Hi,

I'm using Renesas RA6M3 mcu and I'm having trouble selecting Loader on pin P207-P214 for QSPI programming.

As IDE I'm using e2studio RA and I have attached .jlink and .log files.

In .jlink it seems Loaders file is correctly configured:
Loaders="BankAddr=0x60000000&Loader=CLK@P214_nCS@P207_D0@P211_D1@P210_D2@P209_D3@P208"

as the log reports:
T4F30 000:044.943 JLINK_ExecCommand("ProjectFile=C:\...\UVC/UVC Debug_Flat.jlink", ...).
T4F30 000:053.554 Flash bank @ 0x60000000: Stored loader selection. Loader = CLK@P214_nCS@P207_D0@P211_D1@P210_D2@P209_D3@P208

The log continues:
T4F30 000:079.268 ConfigTargetSettings() start
T4F30 000:079.296 J-Link Script File: Executing ConfigTargetSettings()
T4F30 000:079.315 Flash bank @ 0x60000000: New loader selection will not have any effect until debug session restart because device is already selected. Loader = CLK@P214_nCS@P207_D0@P211_D1@P210_D2@P209_D3@P208
T4F30 000:079.326 Flash bank @ 0x60000000: Rejected loader selection because control panel override is active for this flash bank. LoaderRejected = CLK@P214_nCS@P207_D0@P211_D1@P210_D2@P209_D3@P208
T4F30 000:079.338 ConfigTargetSettings() end - Took 42us

I think this is no problem because the pins set is already the correct one.

Upon entering debug, Memory view shows all 0s at 0x60000000.
If I restart debug (without stopping), the Memory view shows the content of the QSPI but it has not been programmed entering debug.


Thanks for any help on this matter,
FP