Flashing Segger JLink Plus Compact using Windows Command Prompt

    This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

    • Flashing Segger JLink Plus Compact using Windows Command Prompt

      Hello,

      I am new to using Segger, I have the J-Link Plus Compact and I was able to use its software (configurator, comnmander, etc...) to talk to and flash a microprocessor chip on a board. Now I need to do this with Windows Command Window (CMD) without going through the Segger available software. Is it possible to do this?

      Thank you