Getting " '.syntax divided' arm assembly not supported " error

    This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

    • Getting " '.syntax divided' arm assembly not supported " error

      New

      I have imported an NXP MCUXpresso project into SES. Import went ahead fine, but compiler gives error
      '.syntax divided' arm assembly not supported

      How can I get around this ? I like to start the projects with MCUXpresso since it gives all the clocks, pins and MCU configs.

      I use Jtrace for debug and I feel SES and Ozone will be a good match with my Jtrace.

      Any leads on '.syntax divided' arm assembly not supported is highly appreciated.

      Thanks

    • New

      Hi,

      thank you for your inquiry.

      Which compiler are you currently using for assembler code?

      Only the unified syntax is supported when using the SEGGER compiler, meaning the divided syntax is not supported at this point.
      Switching to GCC should solve the error.

      Best regards,
      SebastianB
      Please read the forum rules before posting.

      Keep in mind, this is *not* a support forum.
      Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
      Should you be entitled to support you can contact us via our support system: segger.com/ticket/
      Or you can contact us via e-mail.