I'm trying to flash a completed project using J-Link commander instead of from inside Simplicity Studio.

This is what I'm typing into J-Link Commander V7.94i

device EFM32WG232F256
si swd
speed 4000
connect
r
LoadFile C:\Users\Roger\Dropbox\Simplicity Studio V5\Sentinel Lora Master.hex

According to the help, you don't need to give a target Address when using a .hex file, so why is it complaining about parsing that? If I use the value 0 as the address, it still says the same.

Any ideas as to why this doesn't work? I know the .hex file is valid, I can load it from inside Simplicity Studio.

Any help would be greatly appreciated.
Roger

Ok, I've figured this out. It would appear that you can't have any spaces in the filename or path! You have to enclose the whole filename in "quotes"