Hi,
We have a custom board with an NXP IMX RT 1024 chip.
The board has the "internal" flash of the 1024, which is connected to the FlexSPI A1 port.
The board has another flash module, which is connected to the FlexSPI B1 port (Vendor ISSI, type: IS25LP064A).
IMPORTANT:
- The second flash, is the same flash memory module as the 1020 EVK board is shipped with.
- JFlash is capable of erasing my 1021 EVK, thus we can safely conclude our "second flash" is default supported by JFlash
Steps taken:
- Start JFlash
- New project
- device MIMXRT1024xxx5A
- Project settings => Flash => Add flash bank
When I connect to target, and choose manual programming => erase sector, it fails to erase sector on second flash.
Back in project settings => flash => bank 1:
- uncheck "auto detect flash memory"
- select flash device
=> IS25LP064A can't be selected.
Is there a way to configure this anyway?
Many thanks in advance.
We have a custom board with an NXP IMX RT 1024 chip.
The board has the "internal" flash of the 1024, which is connected to the FlexSPI A1 port.
The board has another flash module, which is connected to the FlexSPI B1 port (Vendor ISSI, type: IS25LP064A).
IMPORTANT:
- The second flash, is the same flash memory module as the 1020 EVK board is shipped with.
- JFlash is capable of erasing my 1021 EVK, thus we can safely conclude our "second flash" is default supported by JFlash
Steps taken:
- Start JFlash
- New project
- device MIMXRT1024xxx5A
- Project settings => Flash => Add flash bank
When I connect to target, and choose manual programming => erase sector, it fails to erase sector on second flash.
Back in project settings => flash => bank 1:
- uncheck "auto detect flash memory"
- select flash device
=> IS25LP064A can't be selected.
Is there a way to configure this anyway?
Many thanks in advance.