[ABANDONED] Source Viewer window missing, functions window empty

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [ABANDONED] Source Viewer window missing, functions window empty

    First time using Ozone. Connected a Ubuntu 20.04 pc with an Arduino Due over J-link (swd) and confirmed with J-Link Commander according to the Segger wiki on the topic.
    Have a blink program running, have calibrated Ozone for the Arduino (ATSAM3X8E), and have started a debug session by clicking "Attach to Running Program" and receive a "Connected to Target Device" message in the Console.

    The problem is there is no Source Code Viewer window and the function window is unpopulated. As stated I am very new but have followed step by step a procedure from the wiki so please excuse any obvious mistakes or ignorance.
    Images

    • Ozone.jpg

      564.13 kB, 2,494×1,379, viewed 316 times

  • Hi Ouble,
    your screenshot shows only a short part of the console window. So at this point in time you can expect only guesswork to be done.
    Did you load an ELF file in your Ozone project? Does your ELF file contain debug information? What happens if you attempt to break the target?
    Best regards
    -- AlexD
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.