Hello,

We found some reset timing related issue (about NRST pin toggling) when programming RT1051 with Flasher Portable PLUS:

- "Project settings -> Production": checked "Erase", "Program" and "Verify

- Also checked "Start application -> via reset pin" and "Disconnect afterwards"

- Press PROG to program the part

So I tried to customize the reset pin toggling sequence with "Project settings -> MCU -> Exit steps" to put in:
- "delay" command
- "Reset" command with "Type 2" (i.e. toggle reset pin for this part, note: I tested type 0 and 1 but still no avail)
- etc...
- Uncheck "Start application" and "Disconnect afterwards"
- But the NRST/reset pin is NOT toggled at all after Erase -> Program -> Verify

Is this a bug for NXP RT10XX series when using "MCU -> Exit steps"? Also, is there an alternate way to customize the reset/NRST timing/duration after flash programming?

Environment setup:
- Ubuntu 20
- J-Link v7.84 (also tested v7.84e), 64-bit binary
- Flash Portable PLUS v5.0 (also tested on v1.0)

Thanks,
Alfred