I have tried to figure out the setup connections & create new project for Infineon TC387QP160F300SAE microcontroller.
The device is supported by Flasher Pro (according Segger web site), but is not appearing in selection target list, during creating new project.
I`m using the last J-Flash version784b software and the Flasher Pro programmer updated to the last firmware.
Did someone of you experiences this kind of issue? And what was the solution.
Thank you in advance.
The device is supported by Flasher Pro (according Segger web site), but is not appearing in selection target list, during creating new project.
I`m using the last J-Flash version784b software and the Flasher Pro programmer updated to the last firmware.
Did someone of you experiences this kind of issue? And what was the solution.
Thank you in advance.
The post was edited 1 time, last by iole ().