[ABANDONED] Logs in RTT viewer and SES debugger differences

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [ABANDONED] Logs in RTT viewer and SES debugger differences

    Hello,

    I am trying to debug my project on SES. I connected my board with Jlink and opened RTT Viewer to watch my logs. My project has an RTC watchdog that resets my program in case of a timeout.
    I saved my logs from RTT viewer and then I used SES debugger to see my logs.
    when I compared the logs for a resemble behavior of my code I noticed that the SES debugger printed much more logs than the RTT viewer.

    I wanted to ask what may cause those differences? and which tool will be more accurate to debug my code (RTT viewer or SES debugger)

    The post was edited 2 times, last by lsz: typo ().

  • Hi,
    Thank you for your inquiry.

    The way RTT is read is pretty much the same for ES and RTT Viewer.
    Could you please explain what you mean by "much more logs"?
    Are some log entries skipped when using the RTT Viewer?
    Are you using RTT Viewer and ES at the same time?

    Best regards,
    Fabian
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.