Hello,
I am trying to flash and debug Kendryte K210 microcontroller with Jlink EDU Mini. This microcontroller is based on RV64GC architecture.
To implement that my set-up is:
- J-Link Software and Documentation pack v.7.58 ( segger.com/downloads/jlink/ )
- J-Link EDU Mini V1 compiles Nov 2 2021, HW Version: V1.00, S/N: 801030646, License(s): FlashBP, GDB
- Development Board, Sipeed Maix Bit with Mic
I started with the simple one...that is...flashing and it seems to be that is working well, but when I check the FW in the microcontroller it has the previous FW as you can see in the attached file
I was using Visual Studio Code with PlatformIO and was impossible to flashing and debugging too...
I do not if JLink support this microcontroller...
Thanks in advance.
Jose.
I am trying to flash and debug Kendryte K210 microcontroller with Jlink EDU Mini. This microcontroller is based on RV64GC architecture.
To implement that my set-up is:
- J-Link Software and Documentation pack v.7.58 ( segger.com/downloads/jlink/ )
- J-Link EDU Mini V1 compiles Nov 2 2021, HW Version: V1.00, S/N: 801030646, License(s): FlashBP, GDB
- Development Board, Sipeed Maix Bit with Mic
I started with the simple one...that is...flashing and it seems to be that is working well, but when I check the FW in the microcontroller it has the previous FW as you can see in the attached file
I was using Visual Studio Code with PlatformIO and was impossible to flashing and debugging too...
I do not if JLink support this microcontroller...
Thanks in advance.
Jose.