[ABANDONED] CRC Verification of .bin via J-link ARM

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [ABANDONED] CRC Verification of .bin via J-link ARM

    Hi,
    I have question regarding CRC verification of the data downloaded via Segger device. Below is the snap when I open a .bin file which is to be programmed.
    1. Why I see the CRC of Data and CRC of File as same? Is there any setting I need to do?
    2. After the chip is Erase, programmed and verified attached is CRC in the image appears. The CRC in the message is different than the CRC appeared when the data file is opened. If possible, can you please clarify why I see different CRC?

    Processor Programmed: GD32F303CC
    JFlash tool version: 6.54c

    Thanks
    Images

    • CRC after verification.PNG

      6.86 kB, 367×149, viewed 292 times

    • CRC of data and file before verification.png

      2.19 kB, 528×17, viewed 303 times