[SOLVED] Force JLink to erase everything on Debug->Go

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] Force JLink to erase everything on Debug->Go

    Hello,

    Is it possible to force Jlink to erase all or certain specified areas? Per default, it seems to be only erasing pages that will be written by the uploaded hex.

    Thanks for your tipps.
  • Hello,

    Thank you for your inquiry.
    This is expected behaviour of Embedded Studio.
    As thomasso wrote, if you want to erase the whole chip you can do as he describes.
    If you want to erase only certain sectors, you can either make sure that the affected sectors are part of your application image, or use an external tool like J-Flash which you can find in your J-Link software installation folder.

    Best regards,
    Nino
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.