[ABANDONED] JLink Remote Server Not Working with Tunnel Mode

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [ABANDONED] JLink Remote Server Not Working with Tunnel Mode

    Hello Everyone,
    I have to debug a remote hardware using JLink and IAR.
    I read about JLink Server Tunnel and I think I can use it.
    But somehow I am not able to make it work, can someone please help me in getting this done.

    After unsuccessful attempts, I made remote server on my laptop and tried to connect it using my same laptop but by Remote Server, I think it should work.
    Below are the steps I followed.
    * Used SEGGER Tunnel Server, with Name:Hello and Password:World, with jlink.segger.com server selected.
    * JLink Remote Server Configuration.PNG is attached below.
    * After this from JLink commander I used the following command.

    Shell-Script

    1. ip tunnel:Hello:World:jlink.segger.com

    * After executing the above command, for few seconds I get message in remote server i.e. "Client Authenticated", this is shown in the image "JLink Remote Server Client Autenticated.PNG"
    * But after sometime, I get the error which is as below.

    Shell-Script

    1. J-Link>ip tunnel:Hello:World:jlink.segger.com
    2. Connecting to tunnel:Hello:World:jlink.segger.com
    3. Connecting to J-Link via IP...FAILED: EMU_GetFirmwareString: Insufficient data read when trying to read the string length.
    My main purpose is to debug the project using IAR Embedded Workbench.

    Please check "JLink Remote Server IAR Setting.PNG" file, I used this setting in IAR to Debug and used the following line.

    Shell-Script

    1. tunnel:Hello:World:jlink.segger.com
    But nothing works.


    Can someone please suggest what I am doing wrong?
    Thanks in advance.
    Images

    • JLink Remote Server Configuration.PNG

      468.18 kB, 1,295×684, viewed 408 times

    • JLink Remote Server Client Autenticated.PNG

      656.85 kB, 1,177×729, viewed 457 times

    • JLink Remote Server IAR Setting.PNG

      26.26 kB, 608×490, viewed 370 times

    • JLink Remote Server Not Working-1.PNG

      42.28 kB, 809×409, viewed 415 times

  • Hi,
    Thank you for your inquiry.

    The J-Link Software you are using is fairly old.
    Could you please update the Software on host and client PC and try again?
    You can find the latest version here: segger.com/downloads/jlink#J-L…twareAndDocumentationPack

    If it still does not work after updating:
    1) Could you please send us a J-Link log file? How to enable:
    wiki.segger.com/J-Link_DLL#Enable_J-Link_Log_File
    2) Is it possible to connect to the J-Link directly (using the exact same setup but without the J-Link Remote Server)?

    Best regards,Fabian
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.