We are trying to run some automated power measurement tests on Target hardware(running in 3.3v).
We are using Jlink Base to flash Firmware into Target.
Our flashing steps looks like below
1)power on perm
2)Flash Software into target
3)power off perm
We are trying to understand SWD isolator from Segger ,so that we could use to isolate the target HW form flashing tool that consumes some power.
We need to know the power consumption if any by the isolation circuit itself(if any) after flashing
I understand that at least we have some Led s in the target side.
[img='https://www.segger.com/fileadmin/_processed_/0/7/csm_J-Link_SWD_Isolator_BlockDiagram_80cab56b1f.gif',none,225][/img]
With the circuit mentioned here Isolator still consumes some power from target even if it is isolated.
Since we are not sure of the design of SWD isolator itself,Could you please explain the if we can use SWD isolator for our tests?
We are using Jlink Base to flash Firmware into Target.
Our flashing steps looks like below
1)power on perm
2)Flash Software into target
3)power off perm
We are trying to understand SWD isolator from Segger ,so that we could use to isolate the target HW form flashing tool that consumes some power.
We need to know the power consumption if any by the isolation circuit itself(if any) after flashing
I understand that at least we have some Led s in the target side.
[img='https://www.segger.com/fileadmin/_processed_/0/7/csm_J-Link_SWD_Isolator_BlockDiagram_80cab56b1f.gif',none,225][/img]
With the circuit mentioned here Isolator still consumes some power from target even if it is isolated.
Since we are not sure of the design of SWD isolator itself,Could you please explain the if we can use SWD isolator for our tests?