[CLOSED] J link 5V supply not turning on , with command power on perm

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [CLOSED] J link 5V supply not turning on , with command power on perm

    I am using J link for flashing TLE9879 controller , i have given feed back from 5V pin to Vref pin .
    When i used "power on perm" command , 5V pin still is showing ground and same is reflected in Jlink command
    As VTref=0.000V , when i reopened j link command application .

  • Hi,
    Thank you for your inquiry.

    Could you provide us with a photo of the two pins you connected?

    Best regards,
    Fabian
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.