Hi All,

I'm using floating license for my KEIL IDE and NRF controller.

I'm able to compile and run the code from KEIL but I'm not able to work in debug mode. I'm getting "Error: *** License Mapping Failed! *** Debugger aborted !" this error.

My Jlink version version is 6.46d and windows 10 OS

Here is the build output:

Target info:
------------
Device: nRF52840_xxAA
VTarget = 3.300V
State of Pins:
TCK: 0, TDI: 1, TDO: 1, TMS: 1, TRES: 1, TRST: 1
Hardware-Breakpoints: 6
Software-Breakpoints: 8192
Watchpoints: 4
JTAG speed: 1000 kHz
Full Chip Erase Done.
Programming Done.
Verify OK.
* JLink Info: Reset: Halt core after reset via DEMCR.VC_CORERESET.
* JLink Info: Reset: Reset device via AIRCR.SYSRESETREQ.
Application running ...
Flash Load finished at 17:43:28
Error: *** License Mapping Failed! *** Debugger aborted !


Can anyone help me to fix this issue.

Thanks in advance,

Domneck

I'm not sure from it's from keil or J-link.
Is there any way to check this?

I don't think it's from keil because if it's related to KEIL while compiling itself it will give error.