Hi,
The J-Link Lite included with Renesas RSK board works fine to program the on-board QSPI flash devices. I used the JLink commander version V634h.
It doesn't seem to work when tried to program a custom board that was designed with the same controller device RZA1H as in RSK board.
The custom board differ in the following:
(1) It uses a different QSPI flash (S25FL512S) but supported by JLink program.
(2) It configures SPBIO port 1 as follows (SPBIO port 0 is the same)
SPBIO01 P8_14
SPBIO11 P8_16
SPBIO21 P9_0
SPBIO31 P9_1
Do I need notify the JLink commander (say by command line option) the custom change in the configuration.
Can Jlink identify the ports to which the QSPI devices connected to for automatic programming, as there are only couple combinations available in the device?
Thanks in advance
EsKay
The J-Link Lite included with Renesas RSK board works fine to program the on-board QSPI flash devices. I used the JLink commander version V634h.
It doesn't seem to work when tried to program a custom board that was designed with the same controller device RZA1H as in RSK board.
The custom board differ in the following:
(1) It uses a different QSPI flash (S25FL512S) but supported by JLink program.
(2) It configures SPBIO port 1 as follows (SPBIO port 0 is the same)
SPBIO01 P8_14
SPBIO11 P8_16
SPBIO21 P9_0
SPBIO31 P9_1
Do I need notify the JLink commander (say by command line option) the custom change in the configuration.
Can Jlink identify the ports to which the QSPI devices connected to for automatic programming, as there are only couple combinations available in the device?
Thanks in advance
EsKay