Hi I have just started to get my feet wet with STemWin, bundled in STM32CubeMX. emWin version is 5.44+, running on an stm32f7 discovery board (STM32F756, and 480x272 LCD).
Because maybe I'd like to use it professionally, once I have experience with it.
Unfortunately, I run into some issues, and I have some questions.
- When drawing these shapes: GUI_DrawRect, GUI_DrawRoundedRect, and GUI_DrawCircle, the PenSize is ignored, but other shapes use it. The size was reduced to 1 for these shapes.
Is it expected behavior? Is there a way to set the pen size for above shapes?
- AA variants seem top have the right PenSize, however using GUI_AA_DrawCircle, shows a circle where the outer edges are clipped off, see attached picture.
Is there a way to get the shape drawn right?
- GUI_DrawEllipse does not seem to have an 'AA' variant aka GUI_AA_DrawEllipse.
Or is it there?
STemWin version 5.44+ is the latest version available for ST platforms.
Is it too old?
Could I update it?
My source is here:
github.com/bkht/STemwin-on-stm32f7-dicovery
Thank you very much for helping me out.
Because maybe I'd like to use it professionally, once I have experience with it.
Unfortunately, I run into some issues, and I have some questions.
- When drawing these shapes: GUI_DrawRect, GUI_DrawRoundedRect, and GUI_DrawCircle, the PenSize is ignored, but other shapes use it. The size was reduced to 1 for these shapes.
Is it expected behavior? Is there a way to set the pen size for above shapes?
- AA variants seem top have the right PenSize, however using GUI_AA_DrawCircle, shows a circle where the outer edges are clipped off, see attached picture.
Is there a way to get the shape drawn right?
- GUI_DrawEllipse does not seem to have an 'AA' variant aka GUI_AA_DrawEllipse.
Or is it there?
STemWin version 5.44+ is the latest version available for ST platforms.
Is it too old?
Could I update it?
My source is here:
github.com/bkht/STemwin-on-stm32f7-dicovery
Thank you very much for helping me out.
The post was edited 12 times, last by Jack74044 ().