using embOs and IP on LM3S9B90 after reset geting hard fault exception

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • Hello,

    without more information or even your code I think it is impossible to tell you what is going wrong.
    Which embOS and compiler do you use? Which embOS version?
    Could you please try to step through the code to investigate what happens exactly?

    Regards,
    Til
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.