Hello,
I am working on a STM32F756NG (Cortex M-7).
I am using a J-Link 9.3 probe.
I applied the FreeRTOSV8.2.3_Core.patch on my FreeRTOS 8.2.3 with FreeRTOSConfig.h with:
#define INCLUDE_xTaskGetIdleTaskHandle 1
#define INCLUDE_pxTaskGetStackStart 1
Then I launched my application using IAR Workbench 8.10.1.
My application is running.
So I launched SEGGER SystemView V2.52c and start recording:
- Target device: STM32F756NG
- SWD 2000kHz
- RTT Auto detection
But no RTT Control Block found
I tried to specify the RTT address (0x20000000 0x50000) but it didnt change.
I debug my application and I found that is never called so I put added after the SEGGER_SYSVIEW_Conf
My application is running.
So I launched SEGGER SystemView V2.52c with same prameters as before.
But no RTT Control Block found
I start recording a second time and I observed few traces: see picture
Note that application is still running.
What can I do to observe all the traces ?
Thanks
I am working on a STM32F756NG (Cortex M-7).
I am using a J-Link 9.3 probe.
I applied the FreeRTOSV8.2.3_Core.patch on my FreeRTOS 8.2.3 with FreeRTOSConfig.h with:
#define INCLUDE_xTaskGetIdleTaskHandle 1
#define INCLUDE_pxTaskGetStackStart 1
My application is running.
So I launched SEGGER SystemView V2.52c and start recording:
- Target device: STM32F756NG
- SWD 2000kHz
- RTT Auto detection
But no RTT Control Block found
I tried to specify the RTT address (0x20000000 0x50000) but it didnt change.
I debug my application and I found that is never called so I put added after the SEGGER_SYSVIEW_Conf
My application is running.
So I launched SEGGER SystemView V2.52c with same prameters as before.
But no RTT Control Block found
I start recording a second time and I observed few traces: see picture
Note that application is still running.
What can I do to observe all the traces ?
Thanks