[SOLVED] Using OpenOCD and Ozone on the same JTAG chain

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] Using OpenOCD and Ozone on the same JTAG chain

    Hi,

    I have a J-Link Plus that I use for debugging. I'm about to start working on a board which has 2x ARM micros and an ESP32 and I'd like to put them all on the same JTAG chain. I like using Ozone, and the ARM cores debug fine inside this. However, Espressif only supports OpenOCD for the ESP32 (but it does work with the J-Link, at least when it is the only device on the bus). Is it possible to use OpenOCD and Ozone at the same time, or are these options mutually exclusive?

    Thanks,
    Jeremy

  • Hi Jeremy,

    Thank you for your inquiry.
    Ozone and OpenOCD are mutually exclusive.

    Best regards,
    Nino
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.