Dear all,
I tried to use SWV on a SAME70 board together with JLINK. I start using a Keil MDK project. However, that doesn't work like it was expected. I reached the point where I can see the pin toggling on the SWO pin with respect to my printf commands and at least the timing seems to be OK (not so easy to measure on a 300MHz device). But nothing gets displayed in the corresponding Keil MDK window. Same happens if I try the same example with SES. My printf's get displayed in the 'Debug Terminal' Terminal. However, nothing get's displayed in JLINK SWO Viewer Tool. So I'm not surprised that Keil MDK was not able to show something.
Anyone gets the SWO output working on a SAME70 XPLD board or better what do I need to do get the output redirected to the SWO Viewer?
Best Regards
Markus
I tried to use SWV on a SAME70 board together with JLINK. I start using a Keil MDK project. However, that doesn't work like it was expected. I reached the point where I can see the pin toggling on the SWO pin with respect to my printf commands and at least the timing seems to be OK (not so easy to measure on a 300MHz device). But nothing gets displayed in the corresponding Keil MDK window. Same happens if I try the same example with SES. My printf's get displayed in the 'Debug Terminal' Terminal. However, nothing get's displayed in JLINK SWO Viewer Tool. So I'm not surprised that Keil MDK was not able to show something.
Anyone gets the SWO output working on a SAME70 XPLD board or better what do I need to do get the output redirected to the SWO Viewer?
Best Regards
Markus