Problems with J-Link and IAR V4.30A

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • Problems with J-Link and IAR V4.30A

    Hi,

    there's a problem with J-Link and the IAR Workbench when I try to debug a LPC2148 in the IAR.
    When I try to start a debug session with Ctrl. + D, I get the following error message from J-Link:


    If I follow the instructions from the error message and disconnect/reconnect the J-Link and try to restart the debug session, I get this error message:


    I have:
    IAR Embedded Workbench V4.30A using J-LinkARM DLL V.2.60c
    SEGGER J-Link V6


    Any ideas what's going wrong?

    -Kevin-

  • Hello Kevin,

    The problem is that the J-Link DLL shipped with the IAR EWARM version 4.30A
    or earlier is over 2 years old. This old DLL does not support J-Links with hardware
    revision 6.

    You can solve the problem by downloading and installing a new version of the
    J-Link ARM Software.

    The current J-Link Software is always available for download from our website:
    http://www.segger.com/download_jlink.html

    Short feedback if this solves the problem would be appreciated.

    Best regards,

    Tobias