[SOLVED] J-Link Pro Target current issue

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] J-Link Pro Target current issue

    Hi Sir,

    I'm using J-Link Pro 5V output. It looks the value of target current in the website is error. Maybe the unit should be uA, not mA.
    ?( Please help to confirm. Thank you.




    Ohnail
    1st Oct 2017

  • Hi Ohnail,


    yes this value is uA, not mA.
    Thanks for pointing that out, will be fixed in the next firmware for J-Link PRO.

    Best regards,
    Niklas
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.

  • Hi Ohnail,


    this issue is fixed in version 6.20e of the J-Link software & documentation pack.

    Best regards,
    Niklas
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.