[ABANDONED] J-Link Edu Mini and nRF52832

  • [ABANDONED] J-Link Edu Mini and nRF52832

    Hello,

    I'm new to all this 'arm' stuff so for starters i got a jlink edu mini and nrf52382 breakout board. When i try to connect to it via jtag or swd it gives me a voltage error. So sould i connect the mcu(nrf52832) to a power source before connecting the j link ?Or like is my board is broken ?

  • Hi,

    Welcome to the ARM stuff :)

    nrf52382 breakout board

    Could you post me a link to the board?
    What debug header is mounted on the board? (Cortex-M 19 pin? Cortex-M 9 pin?).
    Or are you using single wires?


    To MCU needs to be powered, otherwise J-Link (or any other debug probe for that matter) will not be able to connect.
    If you have voltage meter at hand, I would recommend to measure the pins of the debug interface in order to make sure that the MCU is powered and that the debug interface is not disconnected by a jumper or there like.


    Best regards,
    Niklas
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.