Has anyone solved the problem debugging with CrossStudio? I have the latest JLINKARM.DLL 6.14b. I can program the target once using the internal Jlink flasher and after that each time I try to reprogram I get either JLINKARM_End_Download_Generic error or a rowley generated verify error. I never again see the Jlink Flasher programing status window.

The only way to fix it is to unplug the JLINK, power down the target, close CrossStudio and start all over again. There has to be some kind of solution for this.

No, that was a completely different issue, which was resolved.

With this issue, when the Jlink is first connected it will program and verify with what looks like the Jlink flasher (a separate windows pops up). From that point forward if the debugger is stopped, code changed, and reprogramming attempted, it will never again program successfully, never again does the separate window appear. Everything has to be shut down and started all over again. I had asked the folks at Rowely and have not gotten an answer as yet. In searching there support forum I have seen a number of problems with Jlink debuggers. For years I used debugging hardware from Rowley (Olimex) without ever seeing this problem. I went to the Jlink so that I could debug an application running under FreeRTOS.

Whatever this is it seems to have degraded over time, when it first appeared about 2 months ago 1 out of 3 attempts would fail. The debugging software in Rowely could be stopped and then restarted. The programming window would appear and all was good. But as of 3 weeks ago, that no longer works. Now everything has to be disconnected and all software has to be closed and restarted.