"Timeout while programming, core does not stop" on DIGI CC9P NS9215

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • "Timeout while programming, core does not stop" on DIGI CC9P NS9215

    Hi everyone,

    when i try to flash the NS9215 with use of RAM enabled i get the "Timeout while programming, core does not stop" message at 35% of Programming progress.
    Speed Test, Erase Sectors and Programming without use of RAM works fine.
    I use the original NS9215 sample from the Sample Project Folder only changed to Little Endian .
    Thanks in advance.

    Regards
    Peter

  • Hello Peter,

    we have checked this with the current software Version of J-Link (V4.08h),
    using the following Test environment:
    J-Flash Sample Project.
    J-Link V6 hardware
    Digi Eval Board CC9P-9215-NET (NS9215 CPU, IS4216400 SDRAM, ST M29W320EB NOR flash)
    Big- and little endian mode

    Everything works fine. I do not see any problems.
    Did you ensure that everything is correctly jumpered on the Eval Board? (Little Endian switch is on, etc.)?

    Best regards
    Alex
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.