JLinkGDBServer device name for Boundary devices nitrogen6X board.

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • JLinkGDBServer device name for Boundary devices nitrogen6X board.

    Hi,

    I am using JLinkGDBServer for debugging bare metal applications on a Boundary device nitrogen6X board. But doing a monitor reset is not working correctly. I guess I am passing a wrong device name for it. Currently I am invoking JLinkGDBServer with -device MCIMX6Q6.

    I am using the following board :

    boundarydevices.com/product/ni…d-imx6-arm-cortex-a9-sbc/

    Help is much appreciated.

    Thanks,
    Bunny

  • Just to update.... I have found out that after doing a "monitor reset" for first time after each power cycle of the target and then trying to load and run my executable causes this problem.
    After this I can do monitor reset for as many times as I want until I power-cycle my target and the program loads and executes fine, but this only works until I again do a power-cycle.

    Plz can anyone help me out..... I am really stuck.

    I am passing a device name MCIMX6Q6

  • It would help if you could let us know *what* does not work.
    You only wrote:
    But doing a monitor reset is not working correctly.

    This does not say anything... What does behave different in contrast to the other times you perform "monitor reset" etc.?


    - Alex
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.