Search Results
Search results 1-6 of 6.
This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.
-
Hello; I try to program renesas R7FA2L1AB via Flasher Compact.While programming stage ; if i get "****** Error: Verification of RAMCode failed @ address 0x20000344." error , i get the verification error at the end of programming If this happens once, I keep getting verification error. If i dont get an error like that,the programming and verification phase complete without any error. I use this script while programming "eoe 1 usb 0 si SWD power on r h loadfile test.hex qc " You can see the log be…
-
Thank you for your support. Problem is solved. As I understand,below lines are used only for cypress programmer.When I deleted these line,I could program the cypress through J-LINK with no error. :0200000490402A :1000000000000000000000000000000000000000F0 :1000100000000000000000000000000000000000E0 :1000200000000000000000000000000000000000D0 :1000300000000000000000000000000000000000C0 :1000400000000000000000000000000000000000B0 :1000500000000000000000000000000000000000A0 :10006000000000000000000…
-
Hello; I have removed all "non existing memory areas. But, i am getting still same error."Failed to open file." The file that you sent is loaded with no errors. Can you send me in Intel Hex 16 bit format the file named "ANAYAZILIM_corrected.hex" like that. :10000000008000201DA902003DDE01003DDE010050 :1000100000000000000000000000000000000000E0 :1000200000000000000000000000000000000000D0 :1000300000000000000000000000000000000000C0 :1000400000000000000000000000000000000000B0 :1000500000000000000000…
-
Hello Nino; I have removed reletaed line from hex. But,i am getting this error. "Failed to open file." Best Regards. Erasing device (CY8C4248xxx-BLxxx)... J-Link: Flash download: Total time needed: 0.083s (Prepare: 0.015s, Compare: 0.0 00s, Erase: 0.064s, Program: 0.000s, Verify: 0.000s, Restore: 0.004s) Erasing done. Downloading file [ANAYAZILIM_2.hex]... Failed to open file. Script processing completed.
-
Hello; You can find all files in the attachments. The HEX file was compiled with IAR for Arm 8.10.1. We are using this programmer. segger.com/products/debug-probes/j-link/models/j-link-plus/ I have also send to you a form via "contact us" page apart from this forum. Best Regards.
-
We are using this programmer; https://www.segger.com/products/debug-probes/j-link/models/j-link-plus/ After this command line; "C:\Program Files (x86)\SEGGER\JLink_V632h\JLink.exe" -device CY8C4248XXX-BLXXX -Speed 12000 -CommanderScript test.jlink We get an error "Writing Memory Failed". You can see all stage of programming below.What is the problem.Why we get this error.We are getting this error,but MCU is working properly. We are waiting for your response. Thank you very much. C:\arcelikC7S>"C…