Search Results
Search results 41-60 of 84.
This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.
-
Hi, I'm successfully running SystemView with my STM32F429 target. The target runs FreeRTOS with lwip (TCP/IP Stack) and an iperf server. I'm using a J-Trace Cortex-M to connect to the target. as soon as I start the bandwithtest, SystemView just displays an error message: Invalid packet received. recording stopped. the test finishes and shows respectable values. I set the SWD frequency to 20MHz, the SystemView Up-Buffer is set to 8KB. How can I prevent SystemView from crashing in this benchmark t…
-
Hi, I'm posting this here because there is no dedicated section for Segger Debugger. Which brings me to the question: is this project abandoned? I was trying to get the thread awareness working in the Segger Debugger. But it does not work as expected. The software running on the target is a FreeRTOS + lwip. The System is up and running. I can ping it. If I try to get a stack trace from a task which is currently not running, the back trace is scrambled. see the attached picture. why is this? How …
-
Hi, might it be possible to add some kind of thread awareness to the GDB Server so eclipse could display the different threads of a system? i recently found this: open-etech.com/Tech/OpenOCD/index.php?page=section2 I'm hoping to get something similar with JLinkGDBServer [img]http://www.open-etech.com/Tech/OpenOCD/thread.png[/img]
-
these commands wont work for me:Quote: “ RAWTRACE protocol: qSeggerRAWTRACE:supported Check if RAWTRACE protocol is supported and if connected emulator supports RAWTRACE Response: "OK" on success or "" or "Error:" on error qSeggerRAWTRACE:start Usually called right before starting the CPU is in decimal, frequence in Hz Response: "OK," on success or "" or "Error:" on error qSeggerRAWTRACE:stop Usually called after CPU has been stopped and before reading trace data are In hex Response: "OK," on su…