Hi,
I'm interested in using J-Link/J-FlashBundle (8.08.11) for external flash programming of a custom ARM based board.
The custom board has:
I need to take the .MEM file obtained from a Green Hills Multi compiler and program it using J-Link/J-Flash into the external Sharp Flash memory.
Regarding the combination of AT91RM9200 and Sharp’s LH28F128BFHT-PTTL75A, I have the following questions:
1. Do I have to set-up or configure the J-Link device?
2. Do I have to set-up or configure a new project for the J-Flash application (including init sequence)?
3. Could I use a sample project (i.e.:AT91RM9200_EK.jflash) and adapt it easily to our board hardware? And after that, save it and use it for next time?
Thanks in advance!
Diego.
I'm interested in using J-Link/J-FlashBundle (8.08.11) for external flash programming of a custom ARM based board.
The custom board has:
- AT91RM9200 uController
- External Flash memory: Sharp LH28F128BFHT-PTTL75A (8Mb x 16)
- External SDRAM: Micron MT48LC8M16A2
- 20 pin JTAG ICE connector
I need to take the .MEM file obtained from a Green Hills Multi compiler and program it using J-Link/J-Flash into the external Sharp Flash memory.
Regarding the combination of AT91RM9200 and Sharp’s LH28F128BFHT-PTTL75A, I have the following questions:
1. Do I have to set-up or configure the J-Link device?
2. Do I have to set-up or configure a new project for the J-Flash application (including init sequence)?
3. Could I use a sample project (i.e.:AT91RM9200_EK.jflash) and adapt it easily to our board hardware? And after that, save it and use it for next time?
Thanks in advance!
Diego.