STM32WB55RG OTP write using JLink

Hello,
I'm trying to read/write the OTP (one time programmable) memory with a SEGGER ARM Flasher on a STM32WB55RG.
I tried to read the OTP memory using JFlash but the results are fake.
Then I tried with JLink and I am able to read the OTP memory correctly.
Now my issue is about writing in the OTP, the write command seems executed properly but when I read the memory I see no modification.
I attached a picture to illustrate the issue.
Is there any operations/settings to do to be able to write in OTP ?
BR
Matt

Below the answer from the support:

Quote from Segger support

J-Link supports internal flash and option byte programming for STM32WB55RG.

https://urldefense.com/v3/__https:/kb…FZFliQOWrDVw%24

OTP programming is currently not supported by J-Link.

If you require flash programming support for the OTP bank, you may implement it yourself using J-Link Device Support Kit (DSK).
https://urldefense.com/v3/__https:/wi…FZFlihgM0Jpg%24https://urldefense.com/v3/__https:/ww…FZFlgo45ICkg%24

The easiest and fastest workaround is to use STM32CubeProgrammer_CLI (ST programming tools) to do this operation.