BTMP Community Member

  • Member since Jul 2nd 2020
Last Activity

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • BTMP -

    Replied to the thread [SOLVED] MAC7111 locked after Chip Erase.

    I was finally able to connect to the target after lowering JTAG speed from 4000kHz to 400kHz. It is odd because normally when there is a program in the flash the target communicates even at 4000kHz. This issue only occurs after Chip Erase command.
  • BTMP -

    Posted the thread [SOLVED] MAC7111 locked after Chip Erase.

    Hello, after Chip Erase JLINK cannot connect to the MAC7111 device any more. This is known issue however I havent found any working solution howto perform JTAG recovery. When I use Target->Manual Programming->Unsecure Chip it returns "Chip unsecured…