HarryHirn Community Member

  • Member since Jun 29th 2020
Last Activity

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • HarryHirn -

    Posted the thread Disable EZ_Port although hard set through pin.

    Thread
    Hi, i got a hardware problem with flashing my board with a Kinetis K22 and the EZP_CS pin. I figured out that the problem is that EZ_Port is enabled due to the pin EZP_CS_not low level at boot up. The level is set by an external IC because i wanted to…