cymatics Beginner

  • Member since Nov 14th 2019
Last Activity

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • cymatics -

    Replied to the thread [SOLVED] JLink EDU and Renesas HEW and E2 Studio.

    Post
    Hi Nino, Thank you for your reply. I'm aware that the Edu model comes without support, so i regret and apologize for my earlier statement. I was so frustrated when i wrote it. Again, apologies. I was able to manipulate the processor's IO registers…
  • cymatics -

    Replied to the thread [SOLVED] JLink EDU and Renesas HEW and E2 Studio.

    Post
    Thanks again. Were you ever able to find any potential solutions mentioned with using JLink with the RX and getting it working? It looks like i'm going to ask for a refund on the JLink Edu. The Renesas E2 Lite is a little cheaper than the Edu. Since…
  • cymatics -

    Replied to the thread [SOLVED] JLink EDU and Renesas HEW and E2 Studio.

    Post
    Thank you for your reply. At least i know that i'm not the only one experiencing this. I have left messages on this Segger website as well as the Renesas website, but so far, i have not heard of any solutions (actually, yours is the first reply i've…
  • cymatics -

    Replied to the thread [SOLVED] JLink EDU and Renesas HEW and E2 Studio.

    Post
    The full message i get in E2 Studio when the mouse pointer hovers over any particular PDR register settings is (eg): Failed to execute MI command: -data-evaluate-expression &(0xFFu) Error message from debugger back end: Attempt to take address of value…
  • cymatics -

    Replied to the thread [SOLVED] JLink EDU and Renesas HEW and E2 Studio.

    Post
    I have been trying to modify the debug settings including GDB Server settings in E2 Studio, but i cannot get the emulator to actually upload the firmware to my board. However, i can toggle the IO register bits on the RX630 through the E2 interface.…
  • cymatics -

    Posted the thread [SOLVED] JLink EDU and Renesas HEW and E2 Studio.

    Thread
    Hi, I have not found this issue on the forum, so apologies if it has been covered already. I recently bought a JLink EDU and have started using it with Renesas' HEW and E2 Studio. In the case with HEW, the emulator setup only allowed me to select the…