afedotov77 Beginner

Hi Fabian, Do you have any ideas about our problem? I still need your help... BR, Andy

Hi Fabian, Additional information. I observe switch on the red LED on the J-Link PLUS during 3-5 seconds. Red LED switches after start donloading program from Ozone BR, Andy

Fabian, answers is below 1) Does this replacing firmware error also appear when you are using J-Link Commander (jlink.exe)? Message about replacing firmware does not always appears and Yes, this message also appear when I using J-Link Commander. 2)…

Fabian, I don't see any difference environment (debugger, scheme, chips and software SEGGER for debugger) between last successful experience and bad experience (when appeared problem). I updated J-Link software up to latest version, but it had fixed…

Hello Fabian, When problem appeared first time I didn't updated Ozone. I updated Ozone later, I hoped to fix problem. But I could not fix problem. I checked voltage between VCC and GND on JTAG in during download .hex file - voltage was stable and equal…

Dear colleagues, will anyone answer? JLinkLogOverride is in in attachment.

Dear, I've recently had a problem using ozone with PLC2387 and LPC 2148. Previously everything worked fine. But now I received following error message from Ozone Device "LPC2387" selected. TotalIRLen = 4, IRPrint = 0x01 JTAG chain detection found 1…