frenchtoast Beginner

  • Member since Sep 6th 2019
Last Activity

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • frenchtoast -

    Replied to the thread "Mass erase done!" repeats forever in Commander.

    Post
    Fixed! The chip was constantly resetting itself apparently. After adding a 1K pullup to 3v3 on the reset pin, all is resolved.
  • frenchtoast -

    Posted the thread "Mass erase done!" repeats forever in Commander.

    Thread
    I'm trying to program a custom SAMD51G18A board over SWD using a Segger J-link EDU Mini. In Atmel Studio 7 > Tools > Device Programming I keep getting this error message: Timed out in cmd Device:startSessionUnable to enter programming mode. Verify