SEGGER - Fabian Administrator

Update: The following steps solved the issue: - In J-Link Commander, connect to the J-Link and issue the following command ResetConf - Powercycle the J-Link - In J-Link Commander, connect to the J-Link and issue the following command Calibrate BR Fabian

Hi Philipp, Sorry for the delay in response. We agree that a crash should be avoided here. We will add a "NULL" (or similar) return message at some point in the future. Please note that we are currently fully booked with projects, so we cannot provide…

Hi, we are not aware of any such issue. Does the issue also occur when using the latest J-Link Software version? segger.com/downloads/jlink#J-L…twareAndDocumentationPack Do you use custom hardware or an evaluation board? In the latter case which one? If…

Hi, Before replacing anything, did you make sure that VCOM was not disabled for the J-Link Compact? wiki.segger.com/Using_J-Link_VCOM_functionality BR Fabian

Hi, - Only one loader is loaded to RAM at a time, and - the RAM region used by the loader is restored after each programming sequence. BR Fabian

Hi, there is no such issue known to us. Would it be possible to send us the FL_Test*.FLM files so we can check on our side? Could you please send us a J-Link log file? How to enable: wiki.segger.com/J-Link_DLL#Enable_J-Link_Log_File BR Fabian

Hi, Thank you for your inquiry. We will answer you in the support ticket system regarding this. BR Fabian

Hi, No, it will not be reverted automatically. As a verification error indicates an issue during programming it would not really make sense to attempt another programming procedure to revert the changes, as this might very well fail again. The data on…

Hi, Requests like this are handled in our Support Ticket system. Could you please create an inquiry regarding this there? Please also add a link to this forum thread, so the supporters know that these cases are related. Best regards, Fabian