SEGGER - Fabian Administrator

Hi, we just gave it a try on the latest MacOS version. Everything worked as expected. Could you please send us a J-Link log file of the failing scenario? How to enable: wiki.segger.com/J-Link_DLL#Enable_J-Link_Log_File BR Fabian

Hi, J-Flash & the J-Flash project format was updated sever times since V5.02l. I would guess that the Project does not work flawlessly with the new J-Flash version. Does it work when you setup a new J-Flash project with the latest J-Flash…

Hi Ali, Did you already check out the troubleshooting guide? wiki.segger.com/J-Link_cannot_…the_CPU#Target_connection Please note that the connection can not be established if RDP was set to Level 2: wiki.segger.com/ST_STM32#Device_security Best…

Hi, Thank you for your inquiry. We are not aware of any such issue. We also highly doubt that the issue lies on J-Link side here. Please find the reason below: 1. The NONMAIN region has a separate flashloader which is only called when the NONMAIN region…

Update: The board arrived. We soldered a 10 pin connector on it and hooked up the J-Link. It did work out of the box on my side (see below). We are confident that this issue is related to your setup (soldering/cable/...) Source Code (23 lines)BR Fabian

Hi, Thank you for the detailed post. 1. To be perfectly honest, the solder job looks horrible, but if you verified that all pins connect correctly andthat there are no short circuits (except for the ones between GND pins), so be it. 2. Regarding the…

Hi Gavin, I had a quick look at this. CORTEX_R52 is currently not pre-defined. I will forward this internally. For now you can use the magic value instead: Source Code (1 line)Note: JLINK_CPU and CPU refer to the same variable. BR Fabian

Hi everyone, this was officially added with the release of J-Link Software Version V7.92i. Excerpt from the release notes: Source Code (1 line) BR Fabian Federschmidt

Hi, I assume that you are using the J-Link SDK, correct? If so, could you please contact us via our support ticket system? segger.com/support/technical-support/ Best regards, Fabian