rabbitlennon Beginner

  • Member since Jul 13th 2019
Last Activity

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • rabbitlennon -

    Replied to the thread ETM on LPC55S69 EVK board.

    Post
    Currently, Ozone reported the following coresight components: CoreSight components: ROMTbl[0] @ E00FE000 ROMTbl[0][0]: E00FF000, CID: B105100D, PID: 000BB4C9 ROM Table ROMTbl[1] @ E00FF000 ROMTbl[1][0]: E000E000, CID: B105900D, PID: 000BBD21…
  • rabbitlennon -

    Posted the thread ETM on LPC55S69 EVK board.

    Thread
    Hi there, I have a LPC55S69 EVK board and wanted to use the Jtrace to get the instruction trace. Since no trace pin is available on the board, I thought setting trace source to be "trace buffer" should work. Unfortunately, it is not allowed in OZone. I…
  • rabbitlennon -

    Replied to the thread Ozone ETM trace limit.

    Post
    Quote from SEGGER - Nino: “You can get around this by exporting the instruction trace data after each stop. This can also be automated. See here for more details: wiki.segger.com/Automated_Tests_with_Ozone ” Thanks for the guide. I used…
  • rabbitlennon -

    Replied to the thread Ozone ETM trace limit.

    Post
    Quote from SEGGER - Nino: “2: Currently not possible. ” If I buy SDK now, can I get a free update with that feature?
  • rabbitlennon -

    Replied to the thread Ozone ETM trace limit.

    Post
    Hi Nino, Thanks for the reply. Quote from SEGGER - Nino: “We are currently working on expanding Ozone and J-Trace PRO so you can select to buffer more data into either your host PCs RAM or to one or multiple trace files. ” 1: Do I need a new J-Trace…
  • rabbitlennon -

    Posted the thread Ozone ETM trace limit.

    Thread
    Hello, It seems there is a hard limit on the captured instructions. In my case, the number of instructions is limited at around 67M, even though I set "Maximum instruction count" to 10G. I wonder if this is a hard limit or something configurable…
  • rabbitlennon -

    Posted the thread Jlink SDK ETM and ITM support.

    Thread
    Hello, I need to capture both ETM and ITM trace at the same time. If I understand correctly, if trace pins are used, both ETM and ITM data are routed to J-trace. However, in the manual of Ozone, it is state that "The simultaneous use of multiple trace…
  • rabbitlennon -

    Now follows SEGGER - Nino.

    Follow