thoFi Beginner

  • Member since Jul 9th 2019
Last Activity

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • thoFi -

    Replied to the thread [SOLVED] VCP problem with J-Link on STM NUCLEO-F103RB.

    Post
    Hello, I have to say sorry, it is a problem with the default USART GPIO Pin configuration generated by CubeMx 5.2.1. Immediately after the USART RX Gpio Pin configuration the STM32F103 pulls its RX Pin low. Changing GPIO_InitStruct.Mode to…
  • thoFi -

    Posted the thread [SOLVED] VCP problem with J-Link on STM NUCLEO-F103RB.

    Thread
    VCP problem with J-Link on STM NUCLEO-F103RB Hello, I use different Nucleo boards reflashed with Segger Jlink. I have a problem with some Nucleo-F103RB boards. The virtual Com port does not seen to work properly. It works correct with STLink VCP,…